Alfa-Sourcing

Rapid prototyping is a powerful tool for development engineers to test product functions with. We are glad to provide the prototyping service you need, for all plastic materials, and with mechanical properties similar to final products.

Test moulds, on the other hand, should be considered in order to validate manufacturing feasibilities and eliminate potential problems before investing into expensive serial moulds. Test moulds are normally built with soft steel or even aluminum, single cavity, and they can be completed in a few weeks and at much less cost, but are good enough for a few thousand shots.

If low volume production is necessary to provide the parts for mass trial, we are ready to assist you too.

Interested? Please email at for a discussion.

http://www.alfa-sourcing.com/